How to flash the Samsung Phone with the help of Odin flasher

Table of Contents

How to flash the Samsung Phone with the help of Odin flasher.

Requirements: Your Samsung Smartphone must have at least 30-40 % of the phone battery to have out the flashing process.

First, you require to open up and extract the firmware bundle which is given below.

Step One: Firstly you will need to download these USB drivers which are essential in this process, after downloading, install these on your PC/Laptop, to set up these you need to have Administrator rights of your PC.

Step two: Download (Stock ROM suited to your device or if you have already downloaded the firmware then overlook getting again) and take it off on your computer. Right after extracting you can see these kinds of files:

Third step: Power Off your cell phone.

Step four: Now, you have as well into the Download mode setting. As well into Download Setting method: Press and Keep Volume Down button, Home button, and Power button. When the phone vibrates release the power button but Maintain holding the Volume down button and Home button. You will boot into the Download Mode.

Step Five: In the Download mode you will conclude up being able to see the Warning Yellow-colored Triangle Indication. In this situation just press the Volume up button to continue.

Stage Six: You need to open and extract the firmware package after the extract opens the Odin3 software which has already been in it, and link the phone with a computer.

Step Seven: Once you have connected the unit to the computer. Odin will automatically identify the device and have got an “Added” message on the lower-left panel.

Step Eight: Once your device is recognized by Odin, click the “PDA” button and select the tar. md5 file you have extracted in Step #2.

Odin3 software flashing method — How to flash the Samsung Phone with the help of Odin flasher

If you have 4files, you must use them to add them at the appropriate place like BL, AP, CP, and CSC.

How to add file in odin3 and start flashing with odin3 software — How to flash the Samsung Phone with the help of Odin flasher

Step Nine: After adding files to the proper place, press the start button to start the flash procedure.

Step Ten: As soon as you see, the Green pass Message, then disconnect the USB cable from the phone (during this procedure, your device will be rebooted automatically).